NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
R7800 fails to connect to internet after upgrade to v1.0.1.28
I have a Netgear Nighthawk R7800 router running firmware version v1.0.0.40 connect to a BT Infinity service via a modem provided by BT.
Everyting thing has been working fine for year with no is...
You'll need to post this over here:
https://community.netgear.com/t5/Nighthawk-WiFi-Routers/bd-p/home-wifi-routers-nighthawk
Modem Combo Units:
Couple of options,
1. Configure the modem for transparent bridge mode. Then use the NG router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ for the IP address the NG router gets from the modem.
3. Or disable all wifi radios on the modem and connect the NG router to the modem, LAN to LAN configure AP mode on the NG router.
I would factory reset the R7800 and set up from scratch and walk thru the setup wizard.