NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

Rel1217's avatar
Rel1217
Aspirant
Oct 18, 2022
Solved

XR1000 GeoFilter RPC Error

I just bought the XR1000 router to hardwire my Xbox Series X to. After installation and setup, I downloaded the newest 1.0.0.64_1.0.49 firmware and factory reset.   All of the apps work except for ...
Troubleshooting
  • Rel1217's avatar
    Rel1217
    Oct 28, 2022

    Hi guys,

     

    Just wanted to follow up on this. I apologize for the delay in response. I was out of town for the last week and not able to try this.

     

    Last night I tried to play an online game with my Xbox Series X and I couldn't connect to online MP. I checked the multiplayer connection and was told I couldn't get a teredo IP address. I did some digging and someone mentioned activating the IPv6 setting on the router fixed their issue. So I activated mine using the Auto Connect setting. Once that was activated and I restarted the router, the error disappeared for the Geo-Filter.

     

    So I never did the manual upload of the new firmware but this did seem to solve for the error. Not sure if that makes sense or something just reset itself in the time I was gone but things seem to be working now.

     

    Thank you guys for all your help and troubleshooting!

FURRYe38's avatar
FURRYe38
Guru - Experienced User
Oct 18, 2022

Ok. Good to know. 

Use the LAN for the ethernet connected PC. 


Be sure you do a full on factory reset and setup from scratch. Do not re-enable Armor at any point. 

Rel1217's avatar
Rel1217
Aspirant
Oct 28, 2022

Hi guys,

 

Just wanted to follow up on this. I apologize for the delay in response. I was out of town for the last week and not able to try this.

 

Last night I tried to play an online game with my Xbox Series X and I couldn't connect to online MP. I checked the multiplayer connection and was told I couldn't get a teredo IP address. I did some digging and someone mentioned activating the IPv6 setting on the router fixed their issue. So I activated mine using the Auto Connect setting. Once that was activated and I restarted the router, the error disappeared for the Geo-Filter.

 

So I never did the manual upload of the new firmware but this did seem to solve for the error. Not sure if that makes sense or something just reset itself in the time I was gone but things seem to be working now.

 

Thank you guys for all your help and troubleshooting!