NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi shows only some of the devices
My topology is as follows: Virgin Media Hub 3 (router) -> GL.inet router running a VPN -> Orbi (AP mode) -> PiHole as a DNS and DHCP server I have a mix of static and dynamic addresses in PiHole...
In AP mode, the orbi isn't handling dhcp at all. Its down to one of the other connected devices.
You've got the gl.inet running dhcp (I'd assume) since you're running it as a VPN.
Plus you have the pihole acting as DHCP.
If you're running both the pihole and gl.inet as DHCP, you've got some network issues. There should only be one dhcp server.
You were right, I hadn't disabled DHCP completely, I just had the DNS server's IP address and had it enabled.
Now I've disabled it, but its IP still shows in ORBI (I've rebooted everything on the network). Plus, I've set a static IP for the ORBI as 192.168.2.2 in my PH, and it's still getting a random IP address.
Skag55 wrote:
You were right, I hadn't disabled DHCP completely, I just had the DNS server's IP address and had it enabled.
Now I've disabled it, but its IP still shows in ORBI (I've rebooted everything on the network). Plus, I've set a static IP for the ORBI as 192.168.2.2 in my PH, and it's still getting a random IP address.
The Orbi isn't managing or doing anything with IP/DHCP while its in AP mode. Thats all to whatever device you have managing it. You might have to reboot devices or release/renew IP address ranges when you're changing dhcp server.
Is it normal to show devices attached to it?
Where should my devices be connected, in the Orbi, or in the GL.inet ? Right now, they're in both, something like half here and half there.