NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Following the latest update the router rebooted twice
Following the latest update the router rebooted twice, never happened before, anybody had similar issues?
Has it rebooted again after two times?
What has going go when you found this?
How did you determine the router rebooted two times?
How was the system updated? Auto update or manual FW load?
What FW version was the system updated too?
Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.
Has a factory reset and setup from scratch been performed since last FW update? A complete pull of the power adapters for a period of time after the factory reset then walk thru the setup wizard and setup from scratch. Recommend setting the default DHCP IP address pool range to the following after applying and a factory reset: 192.168.#.100 to 192.168.#.200.
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6A STP is recommended.
What is the size of your home? Sq Ft?
What is the distance between the router and 📡 satellite(s)? 30 feet or more is recommended in between RBR and RBS🛰️ to begin with depending upon building materials when wirelessly connected.
How are the RBS connected? Wired or wireless?
Updated to V6.3.7.10_3.3.3 RBK 963.
Lost Wifi connection, and router logs showed reboot
[Internet connected] IP address: 192.168.200.114, Saturday, Jan 28,2023 17:22:58
[Initialized, firmware version: V6.3.7.10_3.3.3] Saturday, Jan 28,2023 17:22:50
Didn't factory reseat after update (never done that in 15 years!!!) .
Satellites are connected via wireless backbone. House is 3000SF
ISP is Virgin. Netgear router is connected in router mode to Asus AX86U. Power off of all device has been done following update. Distance is about 44-50 feet
What is the brand and model# of the ISP modem or ONT?
So you have the ISP modem going to the Asus router then the RBR?
Is the RBR in router mode or AP mode here?
Is the Asus routers wifi enabled here?
For that size of home, the RBR and just 1 RBS is needed. Two RBS maybe too much. I have a 5000sq ft home and can get away with 1 RBS at 35-40 feet.
Sometimes a reset is needed after a FW update if problems are seen. NG can differ from other Mfrs.
Lets check a few more this first.
- Modem is virgin hub 3.0. Wi-Fi on ASus is off. Only use ASus for additional security from custom firewall , ad blocker and trendnet. Only one rbs won’t do as I have three floors and a garden house. So horizontal and vertical I cover all the area and get excellent speed. This is a beta router and never got unplanned reboots even during beta. Last two firmwares update were bad, one was disconnecting satellites and this one random reboots…. Do you know what happened to the rbk963 beta firmware test that was meant to take place in January ?
Virgin Super Hubs are also routers and wifi. Be sure the wifi is disabled here as well. Or configured for bridge mode here.
So the Asus is in router mode and is the RBR in router mode as well? I recommend trying AP mode on the RBR if your going to use the Asus has your host router. Probably will stop the reboot. Sounds like something between the ASUS and RBR is causing a reboot to happen. I haven't see this on my beta unit however I run directly to a CAX80 in modem mode or CM2000 cable modems.You might turn down the power as well on the RBR to 50% if your going to run two RBS then. I used this with mine however tesing with 25%, I still get great coverage when I have two RBS deployed.
I also use manual channel 1 and 40.
SIP ALG is enabled as well on mine and use .100 to .200 DHCP IP address pool size when in router mode.
7 and 8 series beta seems to have taken presidence over the 9 series currently.