NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Help Needed! RBS750 Not Connecting, White LED Flashing
Hello everyone, I'm experiencing an issue with my RBS750 where it suddenly stopped connecting and the white LED light keeps flashing. Upon powering on, the LED flashes rapidly and then slows down to...
Two comments:
- I have never used the TTL interface on an Orbi satellite. On an Orbi RBR750, the command line provides access to the usual Linux interface. I have used it to change some settings, but not to "rescue" anything. Sorry not to have anything useful to share.
- The one time I successfully flashed firmware to an Orbi satellite, it was using TFTP to the IP address 192.168.1.250. (That's why the question about "10".)
I have now successfully connected to Orbi via TTL and can see that the terminal is constantly restarting. If I hold down the reset button, the terminal will pause at this command:
'set_firmware_partition:
1017 setenv firmware_partition 0 Setting bus to 0 Valid chip addresses: 31
Setting bus to 0 Valid chip addresses: 31
Setting bus to 0 Valid chip addresses: 31'.
Once I release it, it continues to restart again.
I can't stop the terminal from entering command input mode even when I press Ctrl+C, and I don't know what to do next.
I've uploaded the logs, and it appears that nmrp is also corrupted. I wonder if there's any way to fix it.