NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Need to keep restarting RBRE9606E (AXE) router to get fast Wifi- problem resurfaces AGAIN
Resurface of previous issue. Tried factory reset and that only helped for a week or so... I have a RBRE9606E (AXE), with 2 satellites. Firmware V6.3.7.5_3.2.25 ( I know there is a new FW out. th...
What problem are you seeing?
I see from your last post thread that you didn't give feedback to some questions presented, lets see if we can get some here huh?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6A STP is recommended.
For that size of home, the RBR would only be needed. If you have one RBS deployed, I recommend reducing the power to 25% Under Advanced Tab/Advanced Settings/Wireless Settings
Try setting channel 1 and 40.
Recommend setting the default DHCP IP address pool range to the following: 192.168.#.100 to 192.168.#.200
Hi, Thank you for the help.
Comcast modem is: xFi advanced gateway, Model XB7 CGM4331COM
I have a CAT 6, 550Mhz verified cable betweenModem and Orbing router.
I made your suggested changes:
2.4Ghz set to 1
5Ghz set to 40
LAN set-up set to:
192.168.1.100 to 192.168.1.200
Advanced Wireless settings for 5Ghz and 2.4 Ghz reduced to 25%
For reference I am getting 489 Mbps down, after this change, which is what I always get after a restart of the orbing Router.
Will see if that changes anything?
Your ISP Modem already has a built in router and wifi. This would be a double NAT (two router) condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktopTry option #2 first...
Modem is and has always been in bridge mode.