NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
New - RBR750 / RBS750 Firmware Version v4.6.7.5 Released
No Release Notes at this time. I'll see if I can get some.
Download Link:
https://ntgr.my.salesforce.com/sfc/p/#300000000xsV/a/8b000000saFt/i4cTgMcDmRicn83wLRWla1yba4WYDLOpocfG7QED1Zc
F...
I did the erase on the web interface. The reset was successful. The first 24 hours no drops in internet. Today, a couple of drops for a few minutes.
stlgasman wrote:
I did the erase on the web interface. The reset was successful. The first 24 hours no drops in internet. Today, a couple of drops for a few minutes.
Check "Show Statistics" page to see if there's any packet "Collisions".
Did you power OFF the RBR and RBS for 1 minute or longer then back ON after you update FW?
MIght try a factory reset and setup from scratch.
What is the distance between the RBR and RBS?
SW_ wrote:
stlgasman wrote:
I did the erase on the web interface. The reset was successful. The first 24 hours no drops in internet. Today, a couple of drops for a few minutes.Check "Show Statistics" page to see if there's any packet "Collisions".
FURRYe38Hi there - yeah followed the helpful steps noted in this thread. I think they were off for about 5 minutes and the whole process was painless and went fine. I doubt I would have noticed the weird 2.4Ghz issue, if I hadn't been trying to print, which is quite rare. But apart from that little glitch the firmware is good. Working from home due to the pandemic so getting the time to factory reset is tricky but if I ever get time I might do that.
Ok thought I'd ask. Ya,
See this issue is kind odd for sure. Most everone complains about devices not connecting to the RBS while now yours seems in reverse. You might load up a wifi analyzer if you have a pad handy and see if you see signals from the RBR for 2.4Ghz or not. Hoping a factory reset and power OFF and back ON maybe the key to correcting this behavior.
This version of FW is supposed to be making things better. Hopefully it's going in right directlion but NG is still working on things.
Jimbo84 wrote:
FURRYe38Hi there - yeah followed the helpful steps noted in this thread. I think they were off for about 5 minutes and the whole process was painless and went fine. I doubt I would have noticed the weird 2.4Ghz issue, if I hadn't been trying to print, which is quite rare. But apart from that little glitch the firmware is good. Working from home due to the pandemic so getting the time to factory reset is tricky but if I ever get time I might do that.
Hi there, just a quick question for a noob. I am interested in getting this firmware, but why doesn't it show up in my admin system? I scan for new firmware, and it just says no new firmware. Will this be available via that method eventually, or are manual updates the only way?
Hi,
I think if you scan through this chain you will see it's not an 'official' release, although it is from Netgear. As such your router won;t show it as an option
