NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
New RBK852/853 Firmware v3.2.9.2 Release
New Features and Enhancements: Supports connecting two satellites to the Orbi network Bug Fixes: The Orbi app was not able to show the guest client’s link rate if the Orbi was operating in AP m...
I have found one odd piece of behavior with the new update.
On my system I have 1 x RBR850, 1 x RBS850 and 2 x RBS50s.
The RBS50s are hard wired. The RBS850 is RF Backhauled.
Since the update to this version, the RBS850 reports itself as hard wired even though it is not. It reports this in both the Web GUI as well as the App.
I have rebooted with no change to effect and checked it again after 12 hours -- still the same.
Anyone else see this behavior?
I'll check mine again, however list time I looked both my RBS reported wirelessly connected since both of mine are wirelessly connected.
I have rebooted both satellites as well as router, given them plenty of time to settle in.
It still shows the RBS 850 satellite as hard wired although it is RF Backhauled.
The two RBS50s are hard wired and it shows them properly.
Any ideas on how to unscrew this?
Both App and gui show the satellite hard wired, so it isnt an interface glitch.
How does this get reported to Netgear?
I forgot to check mine.
Try this, turn OFF the entire system. This time, turn ON only the RBR850 and RBS850, leaving the RBS50 OFF. Any change?
