New RBR750 / RBS750 Firmware Version 4.6.3.16 Released

What do you see on the Statisic page while you have AX Mode disabled? 

---

titaniumrx8 wrote:

In the other threads I reported that on 9/14 NG finally gave me access to the beta FW, the same day many were reporting that 4.6.3.16 had become available. NG pushed the update onto my RBK753 before I had a chance to manually install the beta (which is apparently the same as 4.6.3.16)

 

One satellite was reporting on the web page that is was out of sync although there were some devices attached and working. Even though the other satellite was reporting good, there were no devices connected to it, same behavior demonstrated when the last update was pushed.

 

I powered off the router, satellites, modem and every connected device was turned off or wifi disabled. I powered back on in modem-router-satellite1-satellite2 sequence. Each device was not powered on until the previous device was fully online. Then wifi was re-enabled for each device.

 

So far, everything is connected and stable for about 3 hours. Most devices are connected to the most likely device although there are 2 devices reporting that they are connected to the furthest node (both are 2.4ghz devices so this doesn't seem logical because 2.4 is set for 50% power and the connections are 75+ feet and multiple walls in between).

 

I do AX mode is disabled, guest network is disabled, 20/40 coexistence is enable. I'll give this a few days before seeing if AX mode works and guest network will work. I've never had AX mode enabled even on the 3x FW but guest was another casualty of the 4x update.

 

Question, will AX mode make the backhaul channel run on Wifi 6?

---