NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi 850 Satellite Reboot with hardwired Backhaul
Why do i have to discount my ethernet cables for the backhaul to get my satellites to reconnect to the orbi router? This causes a major problem for my home network when i am away from home, as i ...
"Why do i have to discount my ethernet cables" What do you mean by Discount? Do you mean disconnect?
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
What is the size of your home? Sq Ft?
What is the distance between the router and 📡 satellite(s)? 30 feet or more is recommended in between RBR and RBS📡 to begin with depending upon building materials when wirelessly connected.
What is the Mfr and model# of the ethernet switch in the configuration?
https://kb.netgear.com/000051205/What-is-Ethernet-backhaul-and-how-do-I-set-it-up-on-my-Orbi-WiFi-System 📡
What is the size of your home? Sq Ft?
What is the distance between the router and 📡 satellite(s)? 30 feet or more is recommended in between RBR and RBS📡 to begin with depending upon building materials when wirelessly connected.
https://kb.netgear.com/31029/Where-should-I-place-my-Orbi-satellite 📡
Ooops yeah disconnect, got to love that auto-correct!!!
What Firmware version is currently loaded?
V4.6.3.16
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Netgear CM1000 (mine not xfinity's)
What is the size of your home? Sq Ft?
5000Sqft
What is the distance between the router and 📡 satellite(s)? 30 feet or more is recommended in between RBR and RBS📡 to begin with depending upon building materials when wirelessly connected.
router on main floor, 1st satellite in basement and the 2nd satellite on 2nd floor, satellites are around 30 feet from router.
What is the Mfr and model# of the ethernet switch in the configuration?
Netgear CM1000>>>>Dlink DSR250>>>Netgear GS116
Dlink DSR250>>>Orbi RBR850 (connected to WAN port) >>>netgear GS116 (hardwire backhaul)
Satellite 1 RBS850 >>>netgear GS116 (hardwire backhaul)
Satellite 2 RBS850>>>netgear GS116 (hardwire backhaul)
Hope that makes sense!!!
Just noticed basement Satellite has disconnected, not sure why. :(
Thanks
Is the RBR in router or AP mode. I see you have a router in front of the RBR.
What happens if you disable 2.4Ghz AX mode on the RBR?
Set CTS values to 2347 on the RBR.
Has a power off for 1 minute then back ON with the ISP modem and Orbi system been performed since last update?
Ok both satellites discounted sometime in the last 12 hours, rebooted both satellites and still would not reconnect with the ethernet cables connected. Once the ethernet cables were disconnected the satellites would hookup and i was then able to reconnect the ethernet cables to get my backhaul back.
I had already rebooted everything on the network including the modem before this disconnect.