NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi AX4200 RBS750 Satellite
I recently puchased the Orbi AX4200 in an effort to equalize the WiFi strength in my home. My ISP (Windsream) is terrible and provides poor speeds (18mbps) but I was hoping to cover the house with a...
Try moving the RBS closer? 50" maybe a bit too far...Try 40 feet.
1) I moved the Satellite to 30' away from the router
What Firmware version is currently loaded?
2) Firmware says it is up todate but its number is:V3.2.10.10_1.2.12
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
3) ISP Modem: Windstream Wi-Fi Modem - T3200
Any Wifi Neighbors near by? If so, how many?
4) NO actual neighbors. The Windstream WiFi is on and a foot from the NG. Also the Ring WiFi is on and about a foot on the otherside of the NG from the Windstream modem. The Ring is running off the Windstream modem via WiFi. Should it be running off the NG? There is also a Nexia Home Hub runing a few Z-wave devices that is directly connected to the NG via Ethernet cable.
Be sure to check your CTS and RTS values. If they are at 64, please change both to 2346. Reboot both RBR and wireless devices. Under Advanced Tab/Advanced Settings/Wireless Settings
5) No clue how to do this, I can't find an advanced tab on the Orbi App
bgrg2000 wrote:Try moving the RBS closer? 50" maybe a bit too far...Try 40 feet.
1) I moved the Satellite to 30' away from the router
What Firmware version is currently loaded?
2) Firmware says it is up todate but its number is:V3.2.10.10_1.2.12
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
3) ISP Modem: Windstream Wi-Fi Modem - T3200
What mode is this modem working in? Router or Bridge? If router mode, This would be a double NAT (two router) condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop
Any Wifi Neighbors near by? If so, how many?
4) NO actual neighbors. The Windstream WiFi is on and a foot from the NG. Also the Ring WiFi is on and about a foot on the otherside of the NG from the Windstream modem. The Ring is running off the Windstream modem via WiFi. Should it be running off the NG? There is also a Nexia Home Hub runing a few Z-wave devices that is directly connected to the NG via Ethernet cable.
Wifi on the modem needs to be disabled fully. Having the modem close to the RBR with both wifi going will be problematic.
Possible noise and interference near the source RBR is causing the RBS to not work well.
Be sure to check your CTS and RTS values. If they are at 64, please change both to 2346. Reboot both RBR and wireless devices. Under Advanced Tab/Advanced Settings/Wireless Settings
5) No clue how to do this, I can't find an advanced tab on the Orbi App
Use a PC or laptop and a web browser to make changes to the RBR.
I tried using the AP mode on the Orbi AX 4200 system and it crashed! I turned off the wifi signal from my ISP modem, but can only use the Orbi in router mode.
Thank you. I have disabled the WiFi in the ISP modem and the signal consistency seems better. The one thing that is bugging me is this CTS and RTS numbers you mentioned. I still can't find my way into the Orbi. I have tried all the courses on my lap top but still can't gain access.
I was also told by Netgear that I can purchase an RBS850 AX6000 Satellite that is compatible with mine and extend the range more.