ORBI AX4200 strange issue with connections

Not sure what finally did the trick, but now I am back to seeing 500Mbps+ on all devices.

Today I did the following:

1. Turned off the satellites one at a time testing between.  Taking the first satellite out, I started seeing speeds up to 225Mbps again.  This was better than it was before, so I went ahead and unplugged the 2nd satellite and tested.  Speeds only increased to 230Mbps.
2. Plugged an ethernet cable into the router to test the speeds obtained.  This resulted in a major fail because the router refused to give an IP address to the wired connection.  I thought that was a clear indication that the router had failed, but want to fully confirm.
3. Plugged the same ethernet cable into the modem.  Since the modem was pre-configured to have the router turned off, it did not provide an IP Address to the cable either.
4. Did another full shutdown of the complete network and left it all offline for a few minutes.  Brought up the modem, waited until all lights were done blinking.  Brought up the Router and waited until it was fully online.  Tested connection and was seeing 450-520Mbps connections.  Brought up the first satellite and speeds were 440Mbps to 510Mbps.  Brought up the 2nd satellite and speeds went to 480-580Mbps.

I am still running at half the speeds that are coming in the wall, but without the Ethernet backhaul, this is about as good as I can expect.  I will check it again tomorrow, since I didn't really change anything, but so far, it is looking good.  Thanks for your help FURRYe38