Forum Discussion

Guide

Sep 14, 2022

Orbi RBR350 in AP mode - not always getting DHCP IP when roaming

Hi folks, I have a frequent issue with my Orbi setup in AP mode which is quite annoying. When roaming around with my device throughout the house, I often find that I get no connectivity, while th...

ekhalil

Master

Sep 18, 2022

Can you please try this procedure in the wired satellite:
1. Switch off the Satellite
2. Go to Attached Devices in the web GUI and click on the "Disconnect" button beside the Satellite in questions
3. Turn on the Satellite and use a paper clip to factory reset the Satellite
4. When the Satellite is up after factory reset, press the Sync button on the Satellite (while the Ethernet cable to the Router is connected) and then on the Router
5. When the Satellite is added it should behave correctly.

danielschenk

Guide

Sep 29, 2022

I've encountered the issue several times now without the wireless satellite. This means that either the wireless satellite wasn't the cause, or it wasn't the only one.

ekhalil wrote:
Can you please try this procedure in the wired satellite:
1. Switch off the Satellite
2. Go to Attached Devices in the web GUI and click on the "Disconnect" button beside the Satellite in questions
3. Turn on the Satellite and use a paper clip to factory reset the Satellite
4. When the Satellite is up after factory reset, press the Sync button on the Satellite (while the Ethernet cable to the Router is connected) and then on the Router
5. When the Satellite is added it should behave correctly.

I'm currently away from home for a little while but will try this as soon as I get back.