Slow LAN speeds on RBR850, half of what I got on my RBR50

What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6 is recommended. 

How many RBS are deployed? 
What is the size of your home? Sq Ft?
What is the distance between the router and 📡 satellite(s)? 30 feet or more is recommended in between RBR and RBS🛰️ to begin with depending upon building materials when wirelessly connected.
https://kb.netgear.com/31029/Where-should-I-place-my-Orbi-satellite ‌‌🛰

What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and 40 to 48 channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?

️

---

ezjoe21 wrote:

My RBR50 finally gave up the ghost. The firmware was corrupt and I could not figure out how to telnet the firmware to it any longer. So...I replaced my system with an RBR850 and two satellites. The wifi is faster than what we experienced before and seems to be more seamless. However, I used to get 950ish Mb/s to my desktop in my office, and now I get about half that speed. If I swing the cable for my office directly to the cable modem, I am back in the 950 range as expected. Speedtests run from the Orbi management screen show speeds around 1400+ Mb/s. Any ideas on what would be causing such a drop in speed from an RBR50  to an RBR850?

---