NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
After updating to the latest firmware version (1.2.3.28), the RAX120 v1 cannot use "Anywhere Access
Hi, As mentioned in the title, after updating the RAX120 v1 to the latest firmware version (1.2.3.28), I was unable to connect to the RAX120 via the internet using "Anywhere Access" via the Night...
Amend the above description, I mean that after updating to the latest version of firmware, it does not work properly after running RAX120v1 for about 3~7 days.
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Has a factory reset and setup from scratch been performed since last update?
Hi FURRYe38
I'm having a hard time seeing the manufacturer and model of the ISP's modem/ONT, but I can explain the current setup.
My network is connected from the ISP's fiber optic network (300M) to the building's chassis and then to the place where I live, through my home network wiring first to the Netgear Switch Hub (NETGEAR GA308T-100NAS) and then to the RAX120.In addition, I updated the firmware through the management interface and did not restore the factory settings or reset them, because my previous settings would have been lost, which was a bit troublesome for me.
Is it necessary to restore or reset the factory settings to solve this problem?
However, I'm curious if RAX120v1 users will also have this problem after updating to the latest version of the firmware?
Had this been working at some point on the RAX router?
Normal connection methods for routers are ISP services>RAX router<>Lan Switch after the router.
