CAX80 turn off IPV6 and port forwarding

Question

Is there a way to turn off IPV6 on this router? Also im trying to forward port 8003 so i can see my Cameras outside of my network and its saying the port is already being used. I looked at UPNP and it showing port 8003 being used. so i turned off UPNP on my NVR and then tried to forward the port again and it still saying its being used. Someone please help

FURRYe38 · Answer

IPv6 should be under Advanced Tab/Advanced/IPv6.
&nbsp;
Netgear has set up a community forum specifically for the Cable Modem products. Most of the people who watch that forum are more likely to have experience with Cable modems:https://community.netgear.com/t5/Cable-Modems-Routers/bd-p/home-cable-modems-routers
Please use this link to the main forum product list to review and choose where to make your posts.&nbsp;https://community.netgear.com/t5/NETGEAR-Forum/ct-p/en-netgear
Thank you.

TwoTabs · Answer

Thank you, i was able to get open the Ports with UNP but i had to change my Routers IP address a bit. I will post over in the other section

FURRYe38 · Answer

👍
https://community.netgear.com/t5/Cable-Modems-Routers/CAX80-Questions-after-install/td-p/2184743/jump-to/first-unread-message
&nbsp;

Forum Discussion

CAX80 turn off IPV6 and port forwarding

3 Replies