Forum Discussion

christer12's avatar
christer12
Star
Jun 04, 2020
Solved

New Firmware Released RAX40 1.0.3.80 with WPA3

New frimware is here with finally WPA3 and Smart Connect But what more new?
  • tsui's avatar
    tsui
    Jun 08, 2020
    New Features and Enhancements:
    Supports Smart Connect.
    Supports WPA3.
    Supports better device identification in the attached device list.
    Enhances the boot up time.
    Bug Fixes:
    Fixes the WiFi driver crash issue
ZacharyZSun's avatar
ZacharyZSun
Guide
Jun 15, 2020
My wifi just stop broadcasting the signal after a few hours, it happened twice today. The lights are both on for 2.4g and 5g but I can't find the wifi on any of my devices
  • avf0000000000's avatar
    avf0000000000
    Tutor
    Jun 15, 2020

    If you can get into your routers GUI.  You may find that you devices are being blocked.   Mine started with a couple then eventually all were blocked that were on the network.  Had to keep trying new devices until I could get in to unblock. I eventuly gave up did a factory reset.  I then rolled back to my old FW .   Has not crashed since..!   Hopfully Netgear is aware of the issue and is doing somthing about it..

    • ZacharyZSun's avatar
      ZacharyZSun
      Guide
      Jun 15, 2020
      It might be! But the older version of 1.0.3 also has a lot of issues. I don’t have access to 1.0.2 firmware. Don’t know where to find it.
      • ronald_fr's avatar
        ronald_fr
        Luminary
        Jun 16, 2020

        Hello,

         

        my RAX40 has been upgraded to 1.0.3.80 on 12th.

         

        ISSUES :

        • Wifi have lost inthernet access after 8 hours >>> power off on
        • "Attached Devices" is not reliable as some devices are not there (wired or any WiFi on 2.4 or 5 GHz) or all devices from a WiFi chan

         

        to be continued

         

        Ron

         

         

    • Christian_R's avatar
      Christian_R
      NETGEAR Employee Retired
      Jun 19, 2020

      Hi @jrdotmac, The_David, & Retired_Member,

       

      Thank you all for confirming! I'll have the feedback forwarded to the product teams. 

       

      Thanks,

      Christian