Nighthawk RAX80 only allows two devices to connect to internet via wifi in AP mode

Question

I have installed an RAX80 in Access Point mode ( which is intended and what we need it for ) and it is configured with the default

settings to aquire it's IP address etc via DHCP from the main router via the LAN cable.

This works well for the first two people who connect to the WiFi. Any subsequent users that connect to the AP ssid are connected

but with no internet access. If one of the first two , successfully connected users, disconnects, then one of the "new" users then has internet access.

The firmware has been updated to the latest version and the unit has been reset to factory defaults and re set up by just logging into the web interface and going to the advanced tab and activating AP mode.

Any help is much appreciated in advance.

plemans · Answer

What router is it connected to? The primary router is whats controlling the devices. The RAX is only acting as wireless connection.&nbsp;

LDS-Tech · Answer

Hello,&nbsp;It's a Talk Talk Business SuperRouter but essentially it's manufacture is Huawei TechnologiesProduct Type - HG635Device ID - OOEOFC-B8Z8W17AO6952196Hardware Version - G.1.01Software Version - v1.11ttb&nbsp;Thank You&nbsp;

plemans · Answer

If you place the RAX back in router mode (yes, it'll be a double nat) does it allow more devices to connect?&nbsp;

Forum Discussion

Nighthawk RAX80 only allows two devices to connect to internet via wifi in AP mode

3 Replies