NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

Mrteeth2005's avatar
Mrteeth2005
Follower
Sep 23, 2021

Nighthawk X6 Router config with new Fiber added

I just upgraded to 500mbps fiber today. Connected directly to my computer from the IPS's modem, I'm getting around 500meg, as it should. However, everything running on my Netgear Nighthawk X6 is still at 150-180mbps, which is what I was getting before the switch. What can I do to throttle it up so it can get around 400mbps? I know I won't be able to get all 500mg through wifi. 


Thanks

2 Replies

  • plemans's avatar
    plemans
    Guru - Experienced User
    Sep 24, 2021

    Try doing a factory reset and reinstall. 

    Make sure during the install to leave qos, access control, parental controls, and traffic monitoring all disabled. 

  • FURRYe38's avatar
    FURRYe38
    Guru - Experienced User
    Sep 24, 2021

    What Firmware version is currently loaded?
    What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

    Mrteeth2005 wrote:

    I just upgraded to 500mbps fiber today. Connected directly to my computer from the IPS's modem, I'm getting around 500meg, as it should. However, everything running on my Netgear Nighthawk X6 is still at 150-180mbps, which is what I was getting before the switch. What can I do to throttle it up so it can get around 400mbps? I know I won't be able to get all 500mg through wifi. 


    Thanks