NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
No devices showing in detected devices
I just set up an RAX120 in AP mode, and everything seems to be working fine, but it does not show any Attached Devices when connected to my PC using the router's IP address. It does show them in Acce...
Feature for privacy policy
Thank you for your reply, but I'm sorry; I don't understand it.
lmciii wrote:
Feature for privacy policy
Could you please elaborate?
Thanks,
Dave
First I too have the same problem with the RAX120 router, I setup a case with netgear engineers, they do not have an answer yet for this problem(Case was closed) So I call this a now documented feature. For those who have privacy concerns you now have no Idea who is connected to your router unless you go to the access control page in the WEB browser or the Nitehawk app on your phone. Also you cannot change the details of your devices connected. Another value added feature.
lmciii wrote:First I too have the same problem with the RAX120 router, I setup a case with netgear engineers, they do not have an answer yet for this problem(Case was closed) So I call this a now documented feature. For those who have privacy concerns you now have no Idea who is connected to your router unless you go to the access control page in the WEB browser or the Nitehawk app on your phone. Also you cannot change the details of your devices connected. Another value added feature.
Thanks for the clarification. It seems like more people would have this issue.
I read some places where doing a factory reboot after a new firmware upgrade, but I just set this thing up and downloaded the new firmware as advised during setup. I have no desire to set it up again right now.
Hopefully someone else will have more input.
Thanks,
Dave