NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Rax 120-100NAS Reboot Problem
I have a RAX120-100NAS running firmware 1.2.3.28. I noticed it reboots servel times a day. What's astable firmware to use or does anyone have a solution.
I checked the reviews of Netgear routes 120, 200, 500 and they all have a rebooting problem. Thanks for your help
Spectrum EU2251 Firmware 2.76.2
Channels are set to Auto
Near by Spectrum nothing close by
Reset was done. Rebooted after setup.
Does the router reboot if the WAN cable is not connected to the modem?
Might try downgrading FW to v24 and see if this continues or not. IF so, I would presume the router is faulty.
Right now I'm waiting to see if any changes happen after I did a total system reboot after everything was setup. It only reboots a few times a day since I installed it yesterday. I also have a Netgear R7000 that acted the same way. We found a older verison of the firmware that solved the problem. If the reboot doesn't solve the problem then I'll try the channels.
So far since I changed the 2.4 GHz to channel 1 it's been 12 hours and no reboot.
Good to hear. Hopefully this will be the fix. Possible that the other channel is congested with nieghboring signals and causing problems.
Please mark your thread as solved so others will know.
Be sure to save off a back up configuration to file for safe keeping. Saves time if a reset is needed.
Enjoy.