NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Rax periodic reboot
I have installed a RAX120 and an EX8000 as an access point. I also have an EX7500 installed as a wireless extender using the same SSID as the RAX120. This network extender is used primarily to impr...
I've almost the same setup but 2 EX8000 and the router has been as steady as a rock.
couple of quick checks.
Logs are under administration and might show an issue.
Iff connected via PPPoE just under internet setting that the connection is set to always on and not dial up as the router will sleep if no traffic detected.
Perform a factory reset using the rear pin hole and setup as new, do not use a saved profile.
Normally after an update or if you experience issues the reset is a good starting point.