RAX120 assign static IP's to some of my devices?

---

todd1010 wrote:

I have Xfinity internet and I'm pretty capable but before I dig in I want to make sure I'm doing this right. 

 

I want to assign some static ip's to some of my devices so I can do some controlling via IP with a programmable remote control for my home theater. 

 

Couple questions:

 

1) Before I start I understand I should use IP's "outside of the DHCP range correct? If this is true, where do I find this DHCP range?

Under Advanced Tab/Setup/Lan Setup. 

 

2) Before I start I've got a list of all of my devices information I'll need but where do I find all of the DNS, etc so I can input this information into my devices settings. 

 

3) Related to question number 1, I've also read that "some" devices don't like being outside of the DHCP range, if I find a device that doesn't like this I've read that I should us IP addresses in the upper limit of my DHCP range to help with any new devices that I may setup in the future. 

 

To have static IPs work right that are set ON devices, first change the default DHCP IP address pool range to 192.168.1.100 thru .200. Then you can setup and configure static IP address ON devices on ether side of this pool. Anything with in the pool gets Dynamically assigned or IP Address Reservations are meant for inside this pool. 

---