NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

bmoorman's avatar
bmoorman
Guide
Dec 25, 2021
Solved

RAX120 no Web UI

Hello, I can't get access to my Nighthawk anymore. The Web config is not accessable and I get a connection-refused by the browser. This is over the local LAN. I have tried powercycling but that didn...
  • bmoorman's avatar
    bmoorman
    Dec 30, 2021

    Ok. Finally got the Web UI back!

    I decided to flash with tftp using an older version V1.0.0.64. This worked.

    After that I was able to restore the config using a backup of the config.

    I also succesfully updated the version to the latest v1.2.3.28. Thanks for the pointers plemans 

bmoorman's avatar
bmoorman
Guide
Dec 25, 2021

The router is connected to the internet via a fiber gateway/modem, so I do have a double nat issue. But this setup has worked fine before. 

I tried both 10.0.0.1 which is the ip of the router I set it to. I have also tiried via routerlogin.

The Nighthawk does not show its web interface (no connection), I can ping it, I can get new ip address on its guest Wifi. A new phone can't get access to it via LAN Wifi only on guest wifi. Weird. 

plemans's avatar
plemans
Guru - Experienced User
Dec 25, 2021

Have you tried factory resetting it and then during the install, put its ip address into the primary gateway's dmz?