NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAX120 UPNP and Port Forwarding help
I had to do a factory reset of my RAX120 and I'm on firmware V1.2.3.28. I tried to enable UPnP but none of the services kicked in (like NAS boxes external access). I tried to open ports for the s...
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using the port before you use the port checker. The port has to be actively being used to get the status of it.
If you set up a Port Forward configuration, uPnP should be disabled prior as well.
GM_FFX wrote:
I had to do a factory reset of my RAX120 and I'm on firmware V1.2.3.28. I tried to enable UPnP but none of the services kicked in (like NAS boxes external access).
I tried to open ports for the services that were open previously like FTP 21 but when I go test it from the outside the port shows as closed.
Isn't UPnP supposed to add the service automatically? What can I try to resolve this issue?
firmware V1.2.3.28
The ONT is the latest FIOS Gigabit one, it's a small black one, not the old white wall box.
As it turns out it took 8 hours for the ports to actually open and work, I wonder what caused the delay because with the previous system port forwarding was instant.
Odd for sure...should be instant if there being used. 🤔