NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAX20 / AX1800 Remote Management not working.
On my RAX20, I'm needing to access it remotely. The setting is correct for remote management, the port is set. When I place the IP and port (IP:Port) I'm getting page cannot be found. What am I mi...
The IP address I mentioned is the PUBLIC IP from Spectrum assigned to me presently.
> The IP address I mentioned is the PUBLIC IP from Spectrum assigned to
> me presently.
I'll try again.
> What is this "the IP [address]"? From where are you trying to access
> it?
What's the WAN/Internet IP address of the RAX20? To what is the
WAN/Internet port of the RAX20 connected?
If you're worried about revealing secrets, then the top half of an
address, "a.b" out of "a.b.c.d", would satisfy my curiosity.
General advice: Count the question marks ("?"). Count your answers.
WAN IP address from Spectrum is 75.190.x.x. Im trying to connect to it from work, but also tried Chrome on my cell in 5G mode.
Hi microsvc2,
Good day!
Welcome to NETGEAR Community!
First of all, we do apologize for the inconvenience of not getting back to you immediately due to the backlog in the system. Do you still have the issue? What is the current firmware of your router? Have you tried reconfiguring the router? Do you have other Port forwarding rule set on your router aside from the Remote Management?
Please do not hesitate to let me know if you need further assistance.
Regards,
Oliver
Community Team
