NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
RAX20 LAN ports are capped at 100mbs
Hello, my router (info pasted below) does not reliably give me full speed on the LAN ports specifically. I have 900+mb/s to the modem, and if I plug the ethernet cable (cat6) directly into the modem...
Be sure the ethernet drivers are up to date as well.
The RAX only supports up to 1Gb connection rates so you might set a manual connection rate on the adapter for 1Gb only.Please mark your thread as solved so others will know. Be sure to save off a back up configuration to file for safe keeping. Saves time if a reset is needed.
https://kb.netgear.com/24231/How-do-I-back-up-the-router-configuration-settings-on-my-Nighthawk-router
Enjoy. 📡
The LAN port shows a speed of 100M
I am using a CAT6 cable, and when using that same cable directly from the modem I get 500mb/s. I have fiber internet from Surf and the modem is a :
UFiber loco m/n UF-LOCO. Thanks for the quick reply.
What is the devices connected at LAN2?
Does this happen if you switch to other LAN ports?
Do you have another ethernet supported device to help test with to compare?
I only use one device on lan, everything else I use wifi for. The device on LAN2 is my gaming desktop, the same behavior happens on all 4 of the ports. I have a separate desktop that I was fixing for my father, it also gets capped at 100MB with the ethernet cable.
What is the brand and model # of the PC and brand and model# of the ethernet adapter installed in the PC.
I rebooted the modem and the router for about the 5th time and now I'm getting full speed. LAN2 is showing 1000M/FULL now, both desktops are using Realtek Gaming GBe 2.5 chipsets. I'm all set for now, sorry to waste you time.