NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

dmturner's avatar
dmturner
Aspirant
Jan 13, 2020
Solved

RAX200 always crashes when transmitting 900mbps+ (wirelessly only) for more than 10 seconds

This router performs normally with light traffic until it transmits more data. You can stay connected to the network for a bit but even the router's internal web interface will not load. Then you hav...
  • plemans's avatar
    plemans
    Jan 13, 2020

    have you tried to see if the issue happens if you're not running wan port aggregation? I've seen issues with arris running wan port aggregation on my RAX200.

plemans's avatar
plemans
Guru - Experienced User
Jan 13, 2020

have you tried to see if the issue happens if you're not running wan port aggregation? I've seen issues with arris running wan port aggregation on my RAX200.

  • dmturner's avatar
    dmturner
    Aspirant
    Jan 14, 2020

    Thanks for the advice, I should have tested that initially.

     

    That actually resolved the crashing immediately during a speedtest.net test.

     

    It would be great to be able to use the bonding feature but I know none of these ax11000 routers are very well supported yet.

     

    Thanks again!

    • plemans's avatar
      plemans
      Guru - Experienced User
      Jan 14, 2020

      Sadly its not isolated to RAX. My netgear cm1100 worked fine with port aggregation but my arris wouldn't.