NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
JK91
Aug 23, 2024Aspirant
Rax45 Install Not Showing Network
Hello.
Attempting to install RAX45 router and following the app process but get stuck at "connect to router's wifi network" because the "NETGEAR##" network is not showing up as available to connect. I have factory reset twice, turned my modem off and on and nothing.
All lights (power, internet, 2.4, 5.0) are lit white.
All antennas are on the correct connection and tight.
I am setting up from my phone and "local network" is enabled.
My old about to fail router works fine (for a bit, which is why it is being replaced) when plugged into the same network port, so it's not the port.
I don't know the firmware since this is a new setup and I can't even get past the setup screen to check the basic info. Any ideas?? Did I get a defective unit out of the box?
Thanks for any info
3 Replies
Sort By
No RepliesBe the first to reply