NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAX70 Cable can not be detected
Hello, My router out of nowhere cannot detect the modem. I even tried factory reseting the router and then it says that cable cannot be detected. I am out of ideas how to fix this. Plea...
Current firmware version is v1.0.15.146.
Modem is Spectrum ET2251.
I now changed to CAT6 cable. I had some yellow garbage on it.
Yes, I turned off both modem and router for 2 minutes + and then back on, and nothing.
I factory reset and then I again redid the steps and nothing.
Best regards,
David
Can you connect a wired PC or laptop to the modem and see if the PC or laptop gets any internet?
I connected my laptop and it does not recognize the ethernat cable. I will go now exhange the modem.
đ
Exchanged the modem, and the router is back up and running, thank you so much for the help!
Best regards,
David