NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

Htdevane's avatar
Htdevane
Guide
Mar 27, 2020
Solved

RAX80 paired with U-verse Arris BGW210

I have basically done most of the things and I have successfully configured the IP Passthrough and now my Netgear Ax8 is my wireless router over the Arris gateway. When trying to get an open NAT type ...
  • Htdevane's avatar
    Htdevane
    Mar 28, 2020
    You guys are the best! Removed IP Passthrough and enabled AP mode and boom the NAT type immediately went to open and all is well with the wireless connection. I just left the U-verse router Wireless disabled.

    Thank you guys so much because I was literally about to go out and spend money on a mesh network but this AX8 is working good and it seems coverage also isn’t an issue with the router being in the corner of my living room and I’m still getting consistent speeds throughout my 2000sq ft house.
plemans's avatar
plemans
Guru - Experienced User
Mar 28, 2020

If your arris is on the 192.168.1.* and the netgear on the 10.0.0.*, you might not have it setup right. 

att is horrible at setting passthrough to work properly with their service. Many have needed to set the arris in router mode and put the netgear in AP (access point) mode to get gaming/services working properly. 

Have you tried this?