NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Rax80 reverts to factory settings on reboot
HI, I've seen a couple of posts about this, but am at my wit's end with regards to how to fix this issue, if it is even fixable. Have a RAX80, currently on the latest firmware ( V1.0.3.102_1.0.48...
Oh, forgot to mention, I've tried the 30,30,30 reset option as apparently that has fixed the issue on some routers, but to no avail.
Might be related to the R7800 where some units use a Macronix NAND chip. There is currently no fix. Also, a 30-30-30 reset has no effect on ARM-based routers, only MIPS ones. If I was you I'd return it or do an RMA
microchip8 wrote:Might be related to the R7800 where some units use a Macronix NAND chip. There is currently no fix. Also, a 30-30-30 reset has no effect on ARM-based routers, only MIPS ones. If I was you I'd return it or do an RMA
Unfortunately had it just over a year.
ashrahman88 wrote:
microchip8 wrote:Might be related to the R7800 where some units use a Macronix NAND chip. There is currently no fix. Also, a 30-30-30 reset has no effect on ARM-based routers, only MIPS ones. If I was you I'd return it or do an RMA
Unfortunately had it just over a year.
You still have hardware warrenty, no?
Have you tried downgrading the firmare a version?
Sometimes the newer firmware introduces issues. This could be one.
plemans wrote:Have you tried downgrading the firmare a version?
Sometimes the newer firmware introduces issues. This could be one.
Yeah, I reverted down to 1.0.3.88, still the same issue.
