NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RAX80 Wired Connection Speeds
I apologize if this is in the wrong board. I have a brand new RAX80 and am connected to an XFi modem in bridge mode. If I run speedtest from the Nighthawk GUI (advanced>Setup>QoS Setup>Take a Speedte...
There's the same issue reported for the RAX120 where the lan speed drops by about half.
There were some suggestions that turning off QoS fixed the problem but this didn't seem to be a solution for all.
Just another issue in the long list for the RAX devices....
There were some suggestions that turning off QoS fixed the problem but this didn't seem to be a solution for all.
Just another issue in the long list for the RAX devices....
Yeah I just put this router in and I get 450 hardwired and 70-90 wireless even on 5G
On 2.4 it’s only like 25
This thing is a turd so far
On 2.4 it’s only like 25
This thing is a turd so far
I did find that turning on/off QoS really did help. My speeds are as expected now.
- I tried that also and didn’t affect it at all. Maybe this thing just sucks. Guess I will put my ole trusty luxul back in
Try going into setting and enable QoS.... wait a few minutes.... then disable QoS. After doing that should get full speeds... if not try it again and should fix it. If you reboot the router have to do it again. Seems QoS gets enabled even though it shows as disabled so only way to turn it off is to turn it on, wait, and turn it off in GUI.