Forum Discussion

Aspirant

Jun 27, 2021

RAXE500 Link Aggregation Not Working

I purchased a Netgear RAXE500 recently and I'm on the latest firmware (V1.0.5.62_2.0.35). I am unable to setup link aggregation on. I have tried both static and LACP mode using a Netgear and a TP...

joaos

Tutor

Jul 06, 2021

I have LACP multi-gig (1 + 1) working on WAN side, connecting to an Arris modem, with no problem at all, but I had not tried the LAN side as it seems to be your case. Setting up the switch for link aggregation may be a little tricky though. If you have other hardware that supports LA (like NAS, for example), I would give it a try, just to discard the possibility that the problem might be with the router.

Latest firmware is V1.0.6.64, did you upgrade already?

Razor512

Prodigy

Jul 07, 2021

With some managed switches, it can get tricky getting LACP working right, especially when they offer a ton of different methods and hashing types, where it could end up requiring some trial and error.

TP-Link tends to offer a bunch of options on their managed switches for hash algorithm, number of ports used, passive or active LACP, etc.