NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Readyshare stopped recognizing any USB drives
I had not used my 500GB external hard drive in a long while but recently tried to access it and Readyshare portal says "no USB drive" so I tried connecting a small USB drive and it still says "no usb...
Thanks for the reply, the Rax50 only has one USB port, the 500GB SSD uses power from the USB and worked fine in the past, the light on the SSD comes on when I plug it in so I assume it is getting power from the connection.
I might eventually try a factory reset as a last resort but was hoping to avoid that if possible.
Don't remember the format offhand but it was working fine in the past with whatever format it is.
Router firmware version: V1.0.17.142_2.0.100
Possible that the port may have gone bad if the USB drive didn't have it's own power. Most larger sized drives 500Gb and over need additional power. Over time, may have cause the port to go bad.
Would need to factory reset the router and test a small sized drive to see if the port recovers.
Can try reverting back FW version to one prior and see as well.
Thanks for the reply, the Rax50 only has one USB port, the 500GB SSD uses power from the USB and worked fine in the past, the light on the SSD comes on when I plug it in so I assume it is getting power from the connection.
I might eventually try a factory reset as a last resort but was hoping to avoid that if possible.
Don't remember the format offhand but it was working fine in the past with whatever format it is.
Router firmware version: V1.0.17.142_2.0.100
I ordered a new 128GB USB drive and will see if that works with the router, hopefully it does as I am trying to use a factory reset as a last resort.
If that new drive works then maybe my 500GB SSD went bad.