NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Some or might be all Wireless devices can't connect to WIFI if OFDMA andor MU-MIMO seperately are on
Noticed if running OFDMA and MU-MIMO is enabled (one at a time or both at same time) Some devices can't connect to WIFI. So yes, it's possible some older devices, still 5GHz don't support support MU...
Actually looking at older post I did (I'm revisiting) they issue was
Beamforming - Already was enabled
Airtime Fariness- Just enabled and seems OK......
MU-MIMO - Currently disabled
AX Mode- I had this enabled but then could only use 1 oif the 5hz channels. The other one either couldn't be seen or couldn't connect with known good password. So I turned off and was fine after.
Yeah RAX 200
What FW is loaded on the router?
Firmware? Latest that was available via Netgear, but issue persistent between firmware's so ruled out, I suppose
What older devices do you have?
Mainly couple older laptops 4-5yrs Newer ones too
iphone XR - Also had same issue, only 1 channel
Is Smart Connect disabled or enabled?
No
What is the security mode your using on the router? WPA2 or Mixed mode WPA2/WPA3? There are known issues with older devices not being able to connect if mixed mode is set with WPA3 in the mix. Something with these older devices can't connect, even though WPA2 is present. Would be a quick test to see if you disable wifi security with OFDMA and MIMO enabled at the same time, does any of the older devices connect at all? Re-enable WPA2 after checking this.
Not mixed
What channels are you using?
2.4 and 2- - 5ghz
Thanks on "testing" possibilities
Try with SC enabled as well as a test.