Using RX20 as a stand-alone wifi router

Question

Newbie question here.&nbsp;I purchased a RAX20-100NAS to be used in my live audio mixing network.&nbsp;&nbsp;I have a Behringer XAIR XR18 mixer that is controlled from my iPad.&nbsp; The XR18 has its own WIFI but limits the number of connections to 4.&nbsp; I run Mixing Station which uses one connection.&nbsp; There is also an "monitor" app that bandmates can use to tweak their own monitor mixes, with one connection used for each user.&nbsp;The NetGear router connects to the XR18 with a CAT-5 cable and is intended to be the WIFI interface to "the world".&nbsp; The router will never be connected to a cable modem or internet.&nbsp;I want to change the RAX20 WIFI name and set a fixed IP address.&nbsp; If I plug the XR18 ethernet cable into one of the 1-4 jacks (as it would be when I am using it), Nighthawk app finds the router but gets bogged down with "no cable connected".&nbsp; If plug the XR18 ethernet cable into the RAX20 internet jack, Nighthawk says "cables connected" but then bogs down on "Internet not connected".&nbsp;How do I connect to the RAX20 and make these changes?

microchip8 · Accepted Answer

Forget the app. Connect a wired PC to the RAX20 and login into its Web Interface at http://routerlogin.net or http://192.168.1.1 then make the changes as you like.

Forum Discussion

Using RX20 as a stand-alone wifi router

2 Replies