NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
AC1200 WiFi Range Extender, Model EX6150
I want to use this extender in Access Point Mode. It was previously set up in Extender Mode. I did a factory reset and connected it to my router with an ethernet cable. It shows 2 networks: NETGE...
Start over and factory reset it. Push and hold reset for 7-15 seconds while powered on.
Leave it disconnected from your router.
Use the installation assistant but instead of selecting extender mode during the install, use the access point mode. Once you run through setup, then wire it into your router.
How do I install my NETGEAR WiFi range extender as an access point? | Answer | NETGEAR Support