NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
EX6100
Hi all, My EX6100 extender was Firmware Version 1.0.2.28 I found new one and I have updated to EX6100-V1.0.2.6 now I can't access it and enter how to downgrade it to the old version
sami75 wrote:
My EX6100 extender was Firmware Version 1.0.2.28 I found new one and I have updated to EX6100-V1.0.2.6 now I can't access it and enter how to downgrade it to the old version
That sentence is a bit hard to understand.
Are you asking how to access it, how to downgrade it, or both?
What happens when you try to access it on the usual way?
Have you reset it and set it up from scratch?
When it comes to the downgrade, get the older version from the support pages got your device:
Visit the support pages:
Support | NETGEAR
Feed in your model number and that page will have a library of firmwarefor your device.
Look for the model number on the label on the device.
Check the section in the manual on updating the firmware.
Then there is this.
How do I manually upgrade firmware to my NETGEAR router? | Answer | NETGEAR Support
Finally, while many questions about routers are generic and could be answered anywhere, some things need specialist knowledge. In your case, the EX6100 is an extender. You might get more help here:
WiFi Range Extenders & Nighthawk Mesh - NETGEAR Communities
When I upgrade Firmware Version EX6100-V1.0.2.6 I login to the router error message appear (This site can't be reached)
What I want now to to access to the UI and upload the old Firmware Version 1.0.2.28
Reset the device and set it up from scratch following the instructions on the support pages.
How do I perform a factory reset on my NETGEAR router? | Answer | NETGEAR Support
Visit the support pages:
Support | NETGEAR
Feed in your model number and check the documentation for your hardware.
Look for the model number on the label on the device.
Begin with the Quick Start/Installation Guide.I reset the device my ex6100 router and nothing change and still same firmware and still have same error after login (this site can't be reached). I need solution to reset my firmware to the original one.