NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
EX6100
Hi all, My EX6100 extender was Firmware Version 1.0.2.28 I found new one and I have updated to EX6100-V1.0.2.6 now I can't access it and enter how to downgrade it to the old version
When I upgrade Firmware Version EX6100-V1.0.2.6 I login to the router error message appear (This site can't be reached)
What I want now to to access to the UI and upload the old Firmware Version 1.0.2.28
Reset the device and set it up from scratch following the instructions on the support pages.
How do I perform a factory reset on my NETGEAR router? | Answer | NETGEAR Support
Visit the support pages:
Support | NETGEAR
Feed in your model number and check the documentation for your hardware.
Look for the model number on the label on the device.
Begin with the Quick Start/Installation Guide.I reset the device my ex6100 router and nothing change and still same firmware and still have same error after login (this site can't be reached). I need solution to reset my firmware to the original one.
sami75 wrote:
I reset the device my ex6100 router and nothing change and still same firmware and still have same error after login (this site can't be reached). I need solution to reset my firmware to the original one.
I have nothing to add to what I have already said.
I have explained how to reset and access the extender and how to update the firmware,
If you still have problems, tell people what you are doing and where things go wrong.
Simple saying "this site can't be reached" is no help in diagnosing what you are doing.
There are lots of ways of getting that message. Only you know how you got there.
