NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
prosafe wg103 - how do i connect to ifit device
i have purchased ifit wireless device from ifit.com
i am using netgear prosafe wg103 access point.
the ifit recognises device, but will not connect.
message reads :-
Four main reasons for a failed connection:
1. DHCP - make sure that your router has DHCP enabled.
2. 802.11 B - The iFit Live Module only broadcasts on 802.11 B signal, make sure that your router is broadcasting either mixed mode that includes B or just B.
3. SSID - The iFit Live Module can only connect to SSID's that are publicly broadcast, make sure that your router is broadcasting its SSID.
4. MAC Address Filtering - Some routers only allow certain MAC addresses to connect to them. This is common with routers that are configured by your ISP (Qwest, Comcast, Verizon).
how do i solve this problem?
:confused:
i am using netgear prosafe wg103 access point.
the ifit recognises device, but will not connect.
message reads :-
Four main reasons for a failed connection:
1. DHCP - make sure that your router has DHCP enabled.
2. 802.11 B - The iFit Live Module only broadcasts on 802.11 B signal, make sure that your router is broadcasting either mixed mode that includes B or just B.
3. SSID - The iFit Live Module can only connect to SSID's that are publicly broadcast, make sure that your router is broadcasting its SSID.
4. MAC Address Filtering - Some routers only allow certain MAC addresses to connect to them. This is common with routers that are configured by your ISP (Qwest, Comcast, Verizon).
how do i solve this problem?
:confused:
3 Replies
- B mode with WEP.
- b mode with wep ...
can you tell me how i do this please. i am a novice
thanks - log into WG103
you can get manual at support.netgear.com
