NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
WN604 Bridging
Hi all, I bought a WN604 as I was told it could act as a wired -> wireless bridge for me. I've updated the firmware to 2.1. I've put it into Client bridge mode, and defined the Wifi settings ...
I know this issue very well and NG support has no clue about it.
You need to set the default gateway on your IP configuration for WN604 and check the 'Network Integrity Check' box.
I've also an WG102 on the othe end of the WLAN and I'm still facing lost connections, even the above configuration has been completed.
I'm currently testing if it is an overheating of the hardware WN604, when it runs too much traffic.
/Tom
You need to set the default gateway on your IP configuration for WN604 and check the 'Network Integrity Check' box.
I've also an WG102 on the othe end of the WLAN and I'm still facing lost connections, even the above configuration has been completed.
I'm currently testing if it is an overheating of the hardware WN604, when it runs too much traffic.
/Tom