Hi guys,On my company we have two WNDAP350 AP's and we have an issue, we are using MC9090 Symbol handhelds and sometimes the device loose conectivity, I know that is something wrong with the Netgear AP's because I have another linksys and it works great. We bought the Netgear to make a stronger wireless range, but I think right now linksys is working better than Netgear. Do I have to configure something? I already have disabled WMM and Power saving mode, it helps a little but the problem still.Any help would be appreciated.Thank you

if you are leaving on N mode on AP devices , enable WMM when WPA2 are used.I would imagine with symbol they are still on legacy G , would make better to use legacy G ap unit...have you look at open-mesh?... cool stuff

I did notice more stability when I flashed my 350s with the firmware upgrade 2.1.2. I use primarily N machines on both radios. There is a b/g selection if it would provide more stability than the g/n. And I have encountered some problems in the past if the access point was set to wide-channel (40 ghz) instead of 20 ghz.I don't know if you can run WEP with these devices, but I am enjoying pretty good service with this device now.....

40Mhz is for n devicesUse 20mhz /B&G for wireless G devicesWEP is limited to B&G mode for N router/ Aeccess point

jmizoguchi wrote:if you are leaving on N mode on AP devices , enable WMM when WPA2 are used.I would imagine with symbol they are still on legacy G , would make better to use legacy G ap unit...have you look at open-mesh?... cool stuffHi jmizoguchi, I'm in legacy G and I have enabled WMM cause we are using WPA2 5Ghz and the problem remains...

WNDAP350 disconnects frequently | NETGEAR Communities

13 Replies

tonymurillo45
Aspirant
Dec 27, 2011
Hi, yep I'm running the latest firmaware version: 2.1.2. My problem is that something my symbol loose conectivity. I made a ping XXX.XXX.XXX.XXX -t and I made 300 pings and at least 1% is lost.

Thank you
jmizoguchi
Virtuoso
Dec 27, 2011
WMS?

sorry. I got lost with other thread

disregard on symbols.. it was other thread..

what is the wifi adapter model if this pc.

jmizoguchi

Virtuoso

Dec 27, 2011

tonymurillo45 wrote:
Hi, yep I'm running the latest firmaware version: 2.1.2. My problem is that something my symbol loose conectivity. I made a ping XXX.XXX.XXX.XXX -t and I made 300 pings and at least 1% is lost.

Thank you

tonymurillo45 wrote:
Hi, yep I'm running the latest firmaware version: 2.1.2. My problem is that something my symbol loose conectivity. I made a ping XXX.XXX.XXX.XXX -t and I made 300 pings and at least 1% is lost. Thank you

I'm lost in my mind.. it was rich thread..

If I where you I would get legacy wireless G and test out.

some of the legacy wireless G devices will have hard time working with N Access point and routers

if B&G will have an issues with it then I would get different wireless G router to compare the issues

Forum Discussion

WNDAP350 disconnects frequently