NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
AC1750 R6400 port forward stopped working
I installed the R6400 three months ago and the port forwarding worked flawlessly until two nights ago when my two cameras stopped working across the WAN. Here is what I've done so far to fix it. Up...
Figured it out. My ISP modem got scrambled and started handing out a private IP address to the Netgear Router although it was in bridge mode. Replaced it and all is back up and running just fine.
It's enabled.
When using any PF rules, uPnP should be disabled.
Thanks, FURRYe38. I'll give it a try!
Be sure to save settings then do a full reboot of the router and cameras. Let us know how it goes.
Just returned to the house to work on it again, sorry for the delay.
- Disabled UPnP and tested,did not make a difference.
- Backed up, reset router to factory defaults, and setup router from scratch with PF, to no avail.
The frustrating thing is that it was working for months. I even re-installed my original netgear router that also worked, and even the old router doesn't work.
Something has to be going on with my ISP. I'll try there again, unless you have any other ideas.