Bridging a N600 router using a Nighthawk X4S as the primary router

Question

&nbsp;&nbsp;I have recently purchased a new router (Nighthawk X4S) to replace my current (N600 Dual Band Wi-Fi Router).I would simply like to know if i can configure these products as followed:Modem &gt;&gt; New Nighthawk router &gt;&gt; switch&nbsp;&gt;&gt; Old N600 routerI would like to configure the nightawk as my primary router bridging via ethernet to a switch that connects to my N600 router. &nbsp;Can the N600 act as a bridge so that i can mantian a seamless network? Any help with this ould be greatly apreaciated.Best regards, George &nbsp;&nbsp;&nbsp;Model Version: WNDR3400 v3firmware version: 1.0.1.4&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;

TheEther · Accepted Answer

Yes, that'll work. &nbsp;Disable the DHCP server on the N600 and connect it to the network through one of its LAN ports. &nbsp;Leave the WAN port disconnected.

Forum Discussion

Bridging a N600 router using a Nighthawk X4S as the primary router

2 Replies