Netgear WAC104 AC1200 access points disconnect from mesh network

Question

Hello,&nbsp;We have recently installed a number of Netgear WAC104 access points around an office as they are struggeling with wifi ranges. Since we installed it they have advised that the network drops everyday at roughly the same time however any wired connections are fine i.e. VoIP phone, wired PC's, DSL router and main access point stay connected but all the slave access points connected to the master disconnect.&nbsp;&nbsp;Once all the access points are rebooted they start working again.&nbsp;&nbsp;We think it might be something to do with DHCP and lease time.&nbsp;&nbsp;We have reserved the IPs for each access point and the lease time is set to permanent but it still happens.&nbsp;&nbsp;Any ideas why this is happening?&nbsp;Kamil

plemans · Answer

might have better luck in the business AP section instead of the consumer side.&nbsp;https://community.netgear.com/t5/Business-Wireless/bd-p/business-wireless-for-business&nbsp;

Forum Discussion

Netgear WAC104 AC1200 access points disconnect from mesh network

1 Reply