NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
R6220 only showing USB LED light, not even the Power light is on
We just got a new internet service and are trying to connect to our R6220 router. It seemed to be working at first and we were prompted to do a firmware update. The update ended (we are unaware if it ...
Welcome to NETGEAR Community!
You can try to reset the device for 30 seconds if it helps. These light represent that it might be defective already.
Try connecting a computer and check what the IP address connected to a LAN port.
Regards,
Rhys
NETGEAR Community
I'm also facing the same issue the router is not pingable so I can't try the tftp method. I have tried nmrpflash with older as well as newer firmwares but after rebooting the usb light and the respective ethernet LED will glow.
- Hi Anand please share the steps of performinh nmpr flash
- All details are here. Just follow these procedures.
https://github.com/jclehner/nmrpflash- Thank you Anand. NMRP flash also didn't worked because router is not getting ON. It only shows USB led ON only. I have not attached any device to USB port.