NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Should I do a factory reset?
I recently changed internet providers from Comcast at 75mbps to 1 Gig 5G fiber optic. Wifi properties of the Netgear router (shown on my laptop) list the link speeds at 866 receive and 433 transmit....
There's a support site with access to manuals, firmware, install guides, etc.
Go to https://www.netgear.com/support/product/R6220.aspx
Its a great resource to start with for finding those settings.You can access the routers setting through your browser pretty easily.
Or you could just factory reset it and start back at square 1. Never a bad idea when switching isp's or changing speed.
The R6220 is a very base model gigabit device. A couple things.
1. you won't see gigabit speeds over wireless.
2. link speeds are roughly 55-65% of throughput. Meaning if you actually connect at 866mbps, you're actual throughput is only going to be 55-65% of that for 5ghz. 2.4ghz is even worse
3. 2.4ghz is a slow network. its throughput is even lower because of the very nature of how it works.
4. When you test off the built in speedtest, it hosts the test off the router. this isn't always the most accurate as it rarely chooses the best server.
5. With the r6220 being very base model, if you're using any extra monitoring like qos, access control, traffic monitoring, or parental controls, your speeds will drop to what you're experiencing. Its because then the router has to inspect the traffic and its doesn't have enough processor power to do so at gigabit speeds.
so heres where I'd start.
1. disable qos, access control, traffic monitoring, parental controls. Then reboot your device.
2. hardwire a pc/laptop into the router and test off the hardwired device. Not the built in speedtest. try different test servers as when you get to gigabit speeds, some test servers wont' max out gigabit
Try that first and see what you get.
What modem/ont are you connecting to?