NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
6700v3
The other day the signal dropped on this for 45 minutes straight. Every 3 minutes it would reconnect and then within 3 minutes drop again. Re booted the router, rebooted the modem, firmware updated, e...
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6 is recommended.What channels are you using? Auto? Try Auto and 48 on 5Ghz. Or try setting manual channel 1, 6 or 11 on 2.4Ghz and 40 to 48 channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.Has a factory reset and setup from scratch been performed since last FW update? A complete pull of the power adapters for a period of time after the factory reset then walk thru the setup wizard and setup from scratch. Recommend setting the default DHCP IP address pool range to the following after applying and a factory reset: 192.168.#.100 to 192.168.#.200.
Firmware: 1.0.4.128_10.0.104
Modem: net gear cm1000v2
Cable is Cat5e
I am using the Nighthawk app which doesn’t really give me the opportunity, that I have found, to change the channels for each access point. There are plenty of other Wi-Fi signals around. Maybe seven?
I have not done a factory reset, I’m really hoping to not have to set up our entire Wi-Fi again.
Modem: net gear cm1000v2
Cable is Cat5e
I am using the Nighthawk app which doesn’t really give me the opportunity, that I have found, to change the channels for each access point. There are plenty of other Wi-Fi signals around. Maybe seven?
I have not done a factory reset, I’m really hoping to not have to set up our entire Wi-Fi again.
You'll need to log into the routers web page to make changes to wifi channels here.
Last resort would be to factory reset and setup from scratch using a wired PC and web browser.