NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Configure LAN as Wan Port Netgear Nighthawk RAX70
Is there anyway at all to change to a LAN port to WAN port on the Nighthawk RAX70? My WAN port is dead and ive tried everything to check its not just a software issue. I have reseted the router multi...
I have tried restarting my network in that order and no luck. The router was working just fine for a couple of months until this issue appeared.
When the issue first started I was on firmware 1.0.3.92 but I've recently updated to 1.0.11.112 to see if it would help at all, but the problem persists.
I did contact Netgear support and have an open support case but it's been over a month and no response from them.
I'll go make a post in that specific community and see if I have any luck with there.
Thank you.
When the issue first started I was on firmware 1.0.3.92 but I've recently updated to 1.0.11.112 to see if it would help at all, but the problem persists.
I did contact Netgear support and have an open support case but it's been over a month and no response from them.
I'll go make a post in that specific community and see if I have any luck with there.
Thank you.
Be sure you maintain contact with NG support. Keep poking them.
PatienceIsNeede wrote:
I have tried restarting my network in that order and no luck. The router was working just fine for a couple of months until this issue appeared.
When the issue first started I was on firmware 1.0.3.92 but I've recently updated to 1.0.11.112 to see if it would help at all, but the problem persists.
I did contact Netgear support and have an open support case but it's been over a month and no response from them.
I'll go make a post in that specific community and see if I have any luck with there.
Thank you.